The Ballston Metro station (and adjacent bus terminal) sees healthy ridership, but ranks only about 20th in the system for ridership. The high population density doesn’t overwhelm local services. At typical Fairfax County densities, that many residences would require paving over an area the size of Rock Creek Park.) The three Ballston tracts house 8,108 residents in 18 city blocks now. (What’s also lovely about higher-density places is what’s not built instead. Small parks and walkways between buildings offer outdoor breathing room. For decades, Arlington’s plans have encouraged high-rise residential and office on the blocks immediately along the Orange Line corridor, while strictly limiting additional homes even a short walk away.Īll those people in close proximity can support a wide array of dining choices and retailers, including multiple groceries and pharmacies the tract’s 94 Walk Score makes it a “walker’s paradise”. These three tracts make a slice of Ballston the highest-density residential neighborhood in Greater Washington. Image by Daniel Lobo licensed under Creative Commons. The one low-rise building in the region's densest neighborhood is this IHOP. Just east of Quincy is tract 1014.05, the second-densest in Virginia at 72,487 per square mile just west of Stafford is tract 1014.09, with 51,735 residents per square mile. It boasts a population density of 96,758 people per square mile, the highest in the metro area and in Virginia. One of the resulting census tracts, 1014.07, has 3,812 residents clustered on five blocks east of the Metro, around N. A tract that formerly stretched from the Ballston Metro station across the Ballston Quarter mall was split in three, since its population had also grown past 6,000. Four other DC tracts have comparable densities: east of Mount Vernon Square (47.03), along Ogden Street NW in upper Columbia Heights (28.01), around the Columbia Heights Community Center (37.02), and in the northwest part of the Navy Yard neighborhood (72.02).Įlsewhere in the region, another tract split has also uncovered a pocket of even higher density. Smaller pockets of almost-as-high population density are scattered around the District. With DC’s two densest census tracts nearly side by side, Logan Circle is clearly the District’s highest-density neighborhood. Their 2020 population densities are similar to 2010’s, at 58,961 and 69,854 people per square mile, respectively. (The latter’s density is just 35,838 people per square mile, comparable to that of the entire borough of Brooklyn.)Ģ010’s densest tract ( 50.02) was split in 2020 into two even narrower tracts, 50.03 and 50.04. Tracts should have about 4,000 residents, and former tract 52.01 had grown to about 6,000, so it was split into a higher-density 52.03 and a lower-density 52.02. The increase is due less to new buildings than to a geographic split. Image by Bossi licensed under Creative Commons. National City Christian Church is a landmark within DC’s highest-density Census tract. Its population density is 82,591 people per square mile, appreciably higher than the 2010 record-holder. The current densest census tract in DC is now tract 52.03, spanning the three blocks between National City Christian Church on Thomas Circle and the Whole Foods Market on P Street. In 2020, the triangle southwest of Logan Circle, towards Scott Circle, retains its title as DC’s highest-density neighborhood. It assumed that title from longtime champion Columbia Heights. In the 2000s, new infill mid-rises along 14th Street NW north of Massachusetts Avenue NW resulted in Logan Circle becoming the region’s densest neighborhood in 2010. Source: 2020 Census Demographic Data Map Viewer. The map uses new tract boundaries that allow for a finer-grained look at many of our region’s most popular areas.Ģ020 census map showing tract-level population density. Many of the services that make cities tick, like transit systems and shops, depend on having many people nearby and thus on high population density.Īmidst the US Census Bureau’s 2020 data release last week was a new census tract density map. We write about density frequently here at GGWash, and for good reason: great cities and regions are, fundamentally, about bringing a lot of people together - resulting in high population densities. Image by Tony Webster licensed under Creative Commons. This block is in the region's densest neighborhood, according to 2020 census tract data.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |